Craftsman 42 in. Deck 19.5hp Lawn Tractor "tractor blades affect engage" Questions

blades,and probably one or two more in other places.start with the one under your seat by unplugging it and then going ahead with normale start up and implement engagement. you will have found the bad

...not engage but riding mower runs fine. One of front tires is low on air-will this disengage the blade? Hi, No that should not affect it...more likely that you have an electrical problem... ...

...tractor similar to what you describe. Mine runs fine for 15 to 20 minutes and then stalls. It will start back up and run for a few minutes and then stall again. When it stalls it is like when you get ...

blades engaged. Bottoming out will affect the deck but not the motor. In fact, remove the drive belt for the mower altogether and see if the engine runs fine. If this is the case then you have to look

...blades. Ran it to the garage and shut it down. Then tried to start it and trouble shoot it. Started hard then died. now will not even turn over...checked the 20 amp fuses and they are ok. Bad PTO or ...

...blades are engaged or not.If I put my foot on top of the clutch peddle and pulled back on it the mower speeds up but that doesn't work anymore. Have replaced the following parts trying to fix ...

...blades on the EZT as this can affect cooling or damage the EZT. Remove the deck belt Create slack in the belt by pushing the spring loaded idler arm away from the belt. Rotate arm to release belt ...

...engage is there a way to bypass the sensor? Based on the combination problems involving the coil kill wire and the PTO activation, I would suspect the PTO switch is bad. I do not have a schematic for ...

Why won't it start? I have replaced the wires to the battery after they snapped off at the connector; have brand new battery; checked the seat safety switch; checked the spark plug; replaced the fuse;

engage the key. Battery good I cannot find the brake safety switch.Battery good, starter switch good, New solenoid, new 25 amp circuit breaker, continuity between the solenoid and the starter, neutral