...PTO clutch, or in the wiring that goes to it. Inspect the wiring for any obvious spots where insulation has rubbed off or burned. Also look at the wiring at the back of the PTO engagement switch for ...
...electric and controled by a switch(PTO) on the dash 2 reasons. 1 one of your kill switches is faulty example: seat switch which is in an inline circut with your PTO switch could be the problem or a ...
Question about Garden
...used to see this on the Kawaski engine machines with an electric clutch, they put a diode between the two clutch wires so as so as to stop any electrical feed back throught the clutch, when the ...
PTO clutch was bad but on another site, someoen mentioned checking the relay also. If the relay is the cause, seems it would be much cheaper to replace it. Is there a way to verify if it is the clutch
...electric PTO clutch, then it is likely the linkage that operates the PTO clutch is in need of adjustment and/or lubrication. Most use an idler pulley on a V-belt as the 'clutching' mechanism. If the ...
Question about Cub Cadet Garden
electric PTO clutch. This is done by disconnecting the electrical wires first. Then removing the center bolt using an impact wrench. A pull bar can used but you must prevent the engine from turning by
PTO clutch will not engage. Problem stated with a 10 second delay for the clutch to engage, now it will not engage at all. Where is the relay on my cub 2130? How can I test the clutch? first start by ...
electric PTO shorts out when it expands by heat causing it to lose it's magnetic pull and disengages- I hate to say it,but you need a new PTO clutch. Hello From your Description it Sounds like the PTO
Question about Mtd Garden
...PTO clutch and it should drive the V-belt....so If you disconnect the power to the magnet the magnet becomes denergized and the two plates move away from one another ,thus the v-belt stops turning ...
electric pto clutch with a used one. works good for awhile then blows the fuse. never did this before, with the old clutch. could the part be bad, all wiring seems ok please let me know what you think
47 questions posted
Usually answered in minutes!
1,998 Questions
1,006 Questions
710 Questions
725 Questions
285 Questions