Question about Welding Tools
...gas pressure at the gun but full gas pressure at the inlet of the Rossi 185e mug welder. I have changed to gas mode. Can anyone explain please of help ? the liner inside the whip to gun may be ...
...gas pressure I have been mig welding for about 20 years. I have my own fab. shop with several employees. One employee that I have had for 1 year is a great welder & great at fabrication. I have one ...
gas pressure present for the feed motor to operate. Didn't find one. I don't have a schematic for the welder. I was told this unit is from the '80s. 1. Wire jammed 2. Out of wire 3. Not enough tension
...aluminium? first of all good luck welding aluminium with a mig no disrespect intended but your gas pressure with change depending on the place you will be welding at 20psi is a good starting ...
gas and pressure, but none at tip. There must be some fault with the gas solenoid, that is the thing that lets teh gas flow. It will have wires connected to it, when the trigger is pulled it will send
...gas off, purge the line, release the pressure on the regulator, Now turn the gas on and put approximatley 2-3lbs only on the gauge, turn the flow meter for a reading of 15-20ltr/min, then try again, ...
gas outlet holes. Pull trigger and see if you're getting pressure to your gun. If so, check gun o-rings and liner. If the liner hasn't been changed in a while and you use wire lubricants, the gas tube
what is the gas pressure setting for a miller 130xp I use mostly .23 wire and keep the co2 between 10-12, smaller wire less gas
...shielding gas, but there is and at the right regulated pressure If you can feel the stream of gas coming out the gun, then could be that the gas it's contaminated. It happens. I sell gas for
...pressure should the regulator be set at using all gas on regular steel You must use a flowmeter instead of a pressure regulator. Flow must be set 15-25 SCFH depending on where are you working, inside ...
146 questions posted
Usually answered in minutes!
26 Questions
20 Questions
13 Questions