Question about Briggs & Stratton Electrical Supplies
...the throttle. Yes, you will be able to control the throttle. Look for a lever that pulls on the governor spring. On some generators, the governor spring attaches to an arm with adjustment ...
Question about Briggs Electrical Supplies
how to adjust the governor on 13.5 briggs & stratton intek engine? First make sure the throttle lever is on full speed position then unloosen the bolt that holds the governor lever to the shaft ...
Question about Briggs & Stratton Electrical Supplies
...governor arm, springs should be taught when engine is off. The governor spool may also be binding, but much harder to check since it is internal to the engine. Start the generator, and watch the ...
Question about Coleman Electrical Supplies
...governor springs available and different placement holes on the governor arm to attach the spring that will change the power curve. Pulling on the spring can only do so much, however changing the ...
Question about Electrical Supplies
...01924 does it require 2 springs on the governor arm? All of them have 2 springs to keep them centered. One on the governor arm to the engine, and one over the rod that goes from the arm to the
...CARB OFF TO CLEAN OUT "GUM" FROM SITTING. DURING RE-ASSEMBLT SOLID 1/16" ROD FROM GOVERNOR ARM TO THROTTLE PLATE ARM HOOKED UP OK. THEN I DISCOVERED A VERY LIGHT WEIGHT SPRING
Question about Honda Electrical Supplies
unable to control over-revving on Honda gx340, is this a governor issue and how do I fix it?? most likely a governor problem check for broken governor control spring on the arm/lever
Question about Coleman Electrical Supplies
...There are many different models of Briggs used however simple methed is to find the governor shaft. Attached to the small shaft will be a lever with the governor spring and linkage ...
Question about Coleman Electrical Supplies
...arm setting is at It sounds like the govenor spring has become disconnected or the clamp on the governor shaft has become loose and allowed the linkage to get out of adjustment. If problem has ...
...as simple as the engine is no longer running at full speed. This could be caused by binding carb or governor linkages but more often than not the Governor adjustment screw has backed off over time ...
90 questions posted
Usually answered in minutes!
549 Questions
57 Questions
47 Questions