Homelite Consumer Products 9.0 Amp, 14 In. Chainsaw "chainsaw smoking leaking oil" Questions

...smoking The only way a two stroke can smoke is either it is running far too rich ( possible blocked air filter ) or there is too much or incorrect oil in the fuel, if the oil tank for the chain is ...

...chainsaw pull cord wont pull start I pulled cord a couple times (wasn't to easy) and on the third pull I couldn't budge it. Some saws with autotmatic oiling will leak bar oil into the cylinder and ...

...chainsaw and oil leaking that burned, smoke coming out the blade side of the chainsaw. Chainsaw is only 3 weeks old. Oil was in area's that I didn't have oil before. Any ideas? I didn't see leaks or ...

Band new saw. How much brush sparking should there be. The saw sparks inside the motor housing and smoke starts coming out. Stinky smoke. Could bar oil have leaked into motor case? yes it could have .

i recently change the blade on my mower and did not drain the oil prior to doing so , oil leaked everywhere now after the clean up and new spark plug and oil my mower wont start, how can i get it to ...

I just received the tiller in the mail. I filled it up with SAE 30 oil and half filled the gas tank. I started it once and it seemed to run fine until it started to smoke from the engine. Oil started ...

chainsaw which does not stay running. I put in a new spark plug and got it started, used it to cut down a few branches, then it started smoking (due to bar oil running low). I shut it down, filled oil

...chainsaw and about 10 seconds after its started it starts smokeing and bogging out,how do i fix that Check the oil mixture sounds like you have to much oil in gas.try mixing it at 32:1.If it has ...

my stihl 041 saw very old made in germany farmboss but very low hours on it. will pop and smoke a little but not start. When I pull on the starter and it almost starts it gets very hard to pull on ...

After little,but hard use smokes and becomes extremely hot , too hot to handle then takes an age to cool down. When hot , difficulty in reverse mode. sounds like your mix may be too lean on oil ? if ...