Balboa Instruments Duplex Digital Panel 2 Pump "spa control heating" Questions

...control panel If the Ecn or Ec Message is Alternating with the Water Temperature on the Display, the Spa is Operating in the Economy Heating Mode. If the Ecn or Ec Message is ON Solid (Not Flashing) ...

...spa (balboa mrspa1) control panel digital reading when turned on goes to OH,circulation pump will not run OHS, OH, or SPA TEMP LMT Message There is an "Over Heated Spa" (OHS or OH) Water Condition. ...

control panel for it. Id venture to guess it's either a Hawkeye, Barefoot or Master spa if it came with no owners manual. To turn up the heat simply press the Red "up" arrow on the digital control pad

...control on my outside spa.  When I change the temp. setting it reads correctly but then the water continues to heat to original temp.  I press the temp button.  it blinks. I press ...

...the control panel locked?If no check your Hi Limit sensor, it is a thermal protection/overheat sensor which is the spas safety device. If that sensor is bad the spa will not operate/heat at

...control panel, and that was the problem. check your filtration cycle, see if it has been set for Fil 8 or Fil C. this is normally the main fault I see when I visit spa's that are overheating and not ...

...control and heater on a Jacuzzi Spa. The motor starts and runs fine on low speed, but trips the exterior GFI after about three minutes running on high pump. The pump and motor were replaced this ...

...Spa. We recenty replaced the control board with a Balboa VS 510SZ (software version #38). I have two 240v pumps (pump 2 is 2 speed; pump 1 is 1 speed) and a 240v blower. The problem: we have to reset ...

Spa heateer run by Balboa 500Z control box. Standard mode will not shut off. Lowering temp to 88 still gets temp up to104.what is problem? While in standard mode the motor will not shut down after the