turn motor by hand freely. Also removed motor from front connection and can turn impeller freely. (can see whole shaft spinning from impeller to back electrical contact point- - -shaft not broken) Its
...or pool spa store--if motor pump check pump for debris and motor for lube if u can turn shaft or impeller oil motor and work it into bearings if still not turning possible need to replace motor ...
...motor wll not turn on does not turn on It is one of two things 1) your motor has died, or 2) It is not getting electricity. If you can verify proper voltage at the motor and it is not humming or ...
...to turn motor by hand to loosen motor-- when motor doesnt turn it heats up and will turn off till it cools down this is a safety u may get lucky and the motor will run if it hasnt shorted out a ...
Question about Hayward Pool & Spa
...turn the motor to a "Good Spot", the motor will come one. The more dead spots, the higher the chance of pump not coming on without manually turning the shaft. You make the call whether to replace ...
Question about Pool & Spa
...motor does not turn when I turn it on it just makes a humming sound. Can it be fixed ? Century LASAR Pool/Spa motor model # SD-20-2N11CD Probably the capacitor is bad. It can be replaced. Do not let ...
...motor turn i had the pump repaired i then installed it ,it would not pump any water,i tried to bleed it ,just wondering if by chance the direction can get reversed in the motor.it turns counter ...
...on back of motor while off then turn on sometimes it will work if not need new motor You need a new capacitor. Happens all the time on my route and its always the same thing. ...
...to pump switch if voltage turn off breaker remove back of motor where wires go in make sure wires are tight if tight try to turn motor shaft by hand then try again if doesnt work need new motor or ...
76 questions posted
Usually answered in minutes!
20 Questions
20 Questions
12 Questions
4 Questions