Husqvarna "Chain Saw - 16" Bar, 3 Hp "fuel tank vent problems" Questions

...tank vent that will hold some pressure, Don't quote me. But If I turn the saw sideways and the vent allowed fuel to drain out THIS WOULD CREATE A FIRE HAZARD. If the fuel is boiling when you open the ...

...fuel tank vent that could be leaking a small amount of fuel, or the fuel line coming out of the tank could be leaking. Fuel line replacement isn't complicated, you could try installing a new one. If ...

...fuel finder" hose inside the tank. The tank vent is USUALLY a small hole in the tank cap. OFTEN these problems are caused by the diaphram in the fuel pump going bad, or the check valves if it has sat ...

...tank then sucks air through crack, It's a possibility, other than that, check your exhaust port, but sounds like a fuel problem check your fuel tank vent also to make sure it is venting. Good ...

fuel vent, wherever it is located. HTH Lou Check the gas tank when it starts running bad. See if it is building up pressure in the tank. The vent in the cap may be plugged. As the tank gets hotter, it

...fuel tank!! Loosen the fuel tank cap and see if unit will continue to run with out a problem. If the vent is plugged after a few minutes as the fuel leaves the tank a vacuum is created and prevents ...

...fuel tank and building up pressure when the fuel cap vent becomes clogged. When people fill their tanks and overflow fuel leaks down over the engine, the oil in the fuel mixture tends to coat the ...

...tank full of fuel and run saw till you start to hear saw having problems,when this happens loosen fuel cap and see if it helps.Loosening the fuel cap will let air back into the tank if your vent is ...

...fuel tank venting problem--try loosening the fuel cap for a moment when it stops--that will prove the premise. Look for a plugged vent hole in the cap. Make sure that you are using the proper fuel to ...

...fuel tank filter.to get at filter you must empty all gas and fish out fuel line with peice of wire with hook on end.if you look in tank you can see line and filter. As a follow-up to my post of my ...