Husqvarna "Chain Saw - 16" Bar, 3 Hp "bogs down" Questions

My echo cs400 Will start but when I go to disengage brake chain will spin but suddenly the motor starts to bog down for a few seconds then goes back to normal and bogs down ck. the clutch spring

...av,chainsaw bogs down after running just fine for 20 minutes. it continues to idle okay, but will bog down when accelerated Adjust the high speed screw on carb Install a new spark plug Use fresh ...

what causes the chainsaw to bog down and chain to ... What causes the chainsaw to bog down and chain to stop when under light load check chain is sharp oiled and tension is not too tight.if sawis old ...

...bogs down when trying to cut larger branc... Chainsaw bogs down when trying to cut larger branches. Runs fine when not under cutting strain. Seems to smoke too much. I suspect too rich a fuel mix but ...

Why is chainsaw using a lot of gas? Check for leaks in fuel lines, carb,or tank. If none found is the exhaust VERY smokey? If so turn the H needle valve for High CW a bit at a time till the saw still ...

...bogs down when i accellarate and wants to die. Starts good on chocke and revs up when comming off choke to the next stage on the switch. i have adgusted the one carb. setting and get it close but it ...

...down and bogs down. Do I need to adjust the High (H) screw or is there an adjustment that keeps the choke lever from vibrating down too far? Running too lean at full throttle. Yes you need enrich the ...

...BOGS DOWN AFTER 10 MIN OF RUNNING Make sure the bar/chain is not being run dry of oil. Make sure that you are using 50:1 fuel/oil with fresh fuel and modern synthetic saw oil, not boat motor oil. ...

...down, then turn it back in to the center of the two bogs (at the highest point of RPM). Throttle it from idle to WOT and it should be a steady rise in acceleration without bogging down. If it ...

...bogs down when it hits wood my chainsaw starts right up idles fine but it doesn't seem to rev as high and as soon as it hits wood it bogs down and just wont cut for ****. I have changed fuel filter ...