Question about Craftsman Air Tools & Compressors
...runs but will not build more than 20 psi in tank reserve. Whats wrong? 3 gallon 1hp if shuts down at 20 psi regulator is set wrong it runs but only builds 20 psi, compressor is probably worn ...
Question about Stanley Air Tools & Compressors
it always like that? Does the guage on the main tank and the guage on the regulator both not show more than 20psi? When the auto shut-off is triggered do you feel there is more than 20 psi in the tank
Question about Dewalt Air Tools & Compressors
...20 psi before it will pump back up to 100psi The tank check valve is probably bad. Folow the large discharge line off the head, disconnecting one end of it. If you get air out of the line you have a ...
Question about Air Tools & Compressors
build up pressure. The motor runs like normal but only gets about 20 PSI. It is only 2 years old with very little use. it sounds like the regulator is out of whack turning down increases air pressure.
Question about Chicago Pneumatic Air Tools & Compressors
...above 30 PSI. If keeps running and acts as if some sort of by pas has been turned on. It just stops building pressure. Any ideas what to check? Tank check valve or cylinder head reed valves ...
Question about Stanley Air Tools & Compressors
...build up over 20 psi. seems like a lot of air is blowing out of exhaust, is this normal? You may have the pressure release valve stuck open. Check that. If it isn't stuck open. take it back to the ...
...build pressure past 20-30 psi. This compressor is about 4 years old and only recently started doing this. What should i look at replacing to at least get it to build full pressure? Is the pump ...
Question about Craftsman Air Tools & Compressors
...20 lbs of air build up. Air filter is like new, no restriction. Is the compressor rings shot? Oil free pumps do tend to blow the piston ring (not too expensive) available at searsparts.com. Remove ...
...20 psi , and pump still runs. Check the"check" valve. Usually the last part where the air line enters the tank from the compressor. With the compressor turned off and unplugged, loosen the connection ...
...build past 20 psi i do not know how to get to the pistons and stuff what do i do? The problem with compressors not building pressure is usually a bad pressure switch or bad regulator. Does the motor ...
369 questions posted
Usually answered in minutes!
49 Questions
42 Questions
38 Questions