Question about Coleman Electrical Supplies
auto idle. The auto idle solenoid does not work when you throw the switch to auto. Switch is good, replaced the solenoid, still does not work. Any ideas? Generator runs fine at full speed and puts out
...idle condition and when detecting a load will spin up to operate the load. In the off position the unit will remain in the ready for load speed taking the initial load with less hesitation. If this ...
auto idle will not engage when you put a load on it. First if it has a switch to turn the auto idle off try that. if it does not rev up, then the magnetic controller is stuck. There is a magnetic coil
...Auto Throttle and that is the idle control valve (Connected with black and yellow wires) and the Auto Throttle Unit. Start Generator Check for 12VDC on the Yellow wire of the idle control valve. ...
...auto idle to generator I would like to know is it possible to add or convert my generator to have auto idle feature.If so how would I go about it, where can I get parts? -Coleman Powermate Premium ...
Question about Honda Electrical Supplies
...auto throttle is working. when you hit the switch watch the throttle arm move on the carburetor to the idle position,if so you may have to clean the carburetor jet and fuel nozzle ports.possibly this ...
...auto idle control doesnt work, the generator idles fine but when you plug in a tool and try to run it nothing happens. if you manually advance the throttle the tool gets power.. check the spark ...
auto idle or not apon futher investagation I discovered that what I think is the control for this option is not hooked up. There is a plunger type of device that i followed back from the carb throttle
...idle until it sees a load at which time it runs the engine speed up. In the off position, the generator part of this combo is turned off. In my experience, the protection devices on small generators ...
58 questions posted
Usually answered in minutes!
549 Questions
64 Questions
57 Questions
47 Questions