Hitachi CP-X201 Projector "screen 3 switch" Questions

...3 screen appear as 16:9 without loads of white space around the picture. Also, if the motor didn't stop, it wouldn't burn out at low point, as it would simply wind the screen back up the wrong way ...

...screen. 3. Press the MENU button to display the menu screen, and then press the F or G button to select the OPTION menu. 4. Press the ENTER button, and then press the F or G button to select LAMP ...

...screen output way.certainly, it is possible with compatible problem. review your projector instruction, check it can support USB function or not by the manufacturer.hope it is helpful for ...

...3.if yes does the screen show temperature or overheat 4.if yes then one of the cooling fans do not work properly & hence the unit turns to standby & goes into protection if no 1 does not happen, then ...

...for 3 secounds, (message will appear on screen) 4 Press menu button on projector immediately (message on screen) 5 Press left or right button on projector to rest time. 6 All done. Hope this helps ...

screen. press menu button and go to "option" and press enter. go down to lamp runtime. Press and hold the ENTER button for approximately 3 seconds. The "LAMP RUNTIME" will change to "TIME RESET [POWER

...vga output can be seen in 3 modes------ only laptop screen, only external deipaly(projector) & both laptop & projector.check this & this should work fine any further help contact shyam ...

...3 seconds. 7. The confirmation screen will be displayed and select OK. 8. Press the POWER button to turn off for resetting the duration of the LAMP RUNTIME. 9. Next time when you POWER ON the ...

...SCREEN WON'T OPERATE => NO 120V POWER AVAILABE OR OUTBARD SWITCHING PROBLEM => [1] CHECK TO SEE WHETHER THE CIRCUIT BREAKER IS SWITCHED OFF.  RESET IF NEEDED.[2] CHECK OUTBOARD ...

...screen[email protected] friends who were looking for below products, welecome you to contact me, Professiona wholesaler and retailer: for below products1) projecot sapre parts, such as ...