...remote control stopped communicating with my TV after I cleaned (vacuumed) the dust as suggested by manual. I reopened the everything up again and ensure that all the wire and what have you has not ...
...tv right in the middle of the audio video connections. depress the little tab for the filter retainer which looks just like the tab you depress to open the battery cover on your remote. remove the ...
...codes for my tv? Found this in another forum. So apologies if there are any innacuracies. service code menu-5-7-5-7 Press the "AUDIO" button on a remote hand unit to select an adjustment function. ...
...TV is switched Off, the code automatically resets to ?12? No Error. Press the front panel ?DEVICE? and ?MENU? buttons at the same time, and hold for 5 seconds to activate the Error Code Operational ...
...TV (not the remote) and the TV should flash an error code. Here is a chart. Error Code Probable Cause 12 No error detected 22 Recovery from momentary Reset 32 Lamp Cover open 33 Air Filter Cover open ...
...replacement oarts at the following link. The item that says reset on the front of the set is actually a pin hole button. Press a toothpick or similar item into the small hole and hold for a second ...
Question about Mitsubishi WD Televison & Video
TV is switched Off, the code automatically resets to "12" No Error. Pressing the front panel "DEVICE" and "MENU" buttons at the same time, and holding for 5 seconds, activates the Error Code Mode. The
...TV was on before you used the SYSTEM RESET button may be lost, however, the changes that were previously saved are not lost. Try this and let me know. Good Luck. this is an intermitent solder (dry ...
Question about Mitsubishi WD Televison & Video
...TV technicians who are also engineers agree that this works, but the cost due this method is not a good one, you still do not take care of the central problem which actually is sharp increases of ...
Question about Mitsubishi WD Televison & Video
...tv comes on for a few seconds then goes off. i check the code and it is a 18, this code say that it is a loose pe or pe2 cable. upon inspection the cable looks fine, what can i do to fix issue? Try ...
72 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions