Question about Midea Heating & Cooling
...temperature sensor open or short circuit The prescribed cure: Check to make sure the room temperature sensor is connected and reads the correct resistance value. If the sensor operates correctly, ...
...sensor is part of the thermostat assembly. It controls the room temperature to whatever temperature it is set at. If the temperature varies too much, you may need a new thermostat. Other problems ...
Question about Heating & Cooling
check the temperature sensors. Room temperature sensor and coil temperature senor. If you wish to get some details; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com
...temperature sensor Sensor Cable left side yellow. My airco got visited by a rat and damaged the wiring. Cut it rejoined and code 32 changed into temperature. You need the sensor. Just joining the ...
...temperature sensor Sensor Cable left side yellow. My airco got visited by a rat and damaged the wiring. Cut it rejoined and code 32 changed into temperature. You need the sensor. Just joining the ...
...temperature sensor. Condition: 4 times occurrence within 20 minutes Possible causes: • Refrigerant shortage (refrigerant leakage). • 2/3 way valve closed. • Detection error due to faulty compressor ...
Temperature Sensor. Heating and cooling operation will be locked out. Fan operation can continue to operate. E3 Shorted Indoor Temperature Sensor. Heating and cooling operation will be locked out. Fan
temperature sensor. one or both of these sensors is defective, so that electronic controller error and showed signs of a green light flashes and the remote does not work. You must replace both sensors
Question about Honeywell Heating & Cooling
...will display the temperature at the sensor location (the internal sensor in the thermostat is not used). \ 0 No remote sensor 1 Outdoor sensor (display only) 2 Outdoor control sensor (select heat ...
Question about GE Heating & Cooling
...temperature sensor Sensor Cable left side yellow. My airco got visited by a rat and damaged the wiring. Cut it rejoined and code 32 changed into temperature. You need the sensor. Just joining the ...
70 questions posted
Usually answered in minutes!
347 Questions
334 Questions
307 Questions
96 Questions
89 Questions