...analog pressure sensor has failed. First you will need to remove the top lid. Usually 2 or 3 screws on the back and the top comes right off. The pressure switch has a clear hose and a clump of wires ...
...analog pressure sensor, a problem with the air tube connection between the analog pressure sensor and the bottom of the washer tub or a failed central control unit.If you remove the top panel, three ...
...analog pressure switch located under the top cover panel in the back right corner of the washer (as viewed when standing in front of the washer looking down at the top). I called the Whirlpool ...
...analog pressure switch. "Sud" may display 4 minutes prior to F35. Run a cycle without using detergent to clear possible sud lock condition. The first thing to check is the pump filter located behind ...
Analog pressure switch issues You can remove this switch and blow into the tubing to check the switch for working, this is pressure activated diaphragm and it must contact the switch unless the ...
...ANALOG PRESSURE SENSOR switch operation (key#20). There could be a blockage in the air dome or pressure switch hose. The pressure switch is located underneath the main top on the right hand side.The ...
...analog pressure sensor (water level pressure switch) in the washer. This component senses and controls water level in the washer. This failure could be caused by a pinched or broken air hose between ...
...analog pressure sensor (water level pressure switch) in the washer. This component senses and controls water level in the washer. This failure could be caused by a pinched or broken air hose between ...
ANALOG PRESSURE SENSOR switch operation Could be a blockage in the air dome or pressure switch hose (Item 29). The pressure switch is located underneath the main top on the right hand side. (See image
127 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions
