...filter board next to this board for power going to the cable you had to remove on the board to open the cover for line voltage from the power filter board first,as sometimes this board can go bad ...
...mains power into the board and power supply, check for burnt surge protector which could have burnt the fuse. Also a short in the circuit could have done the same, if not the board must be
Question about Fisher and Paykel Washing Machines
...board replacement: Disconnect the power connector and sensor switch assembly. Remove the main board protective cover. Disconnect the connectors. Remove the screw on the back of the main board. Slide ...
...on Possible failure of the main control board , remove the power and trace power to the control panel, if power is present then it is failure of the board, if not check the power cord, plug or
...power cord to the control board and make sure there's power there. If none, replace the power cord; otherwise, the control must have burnt out and only replacing it will solve the problem. The ...
Question about Fisher and Paykel Washing Machines
...power in the outlet You will need to unplug the washer, remove the 4 screws from the white plastic pieces on the rear of the machine main top, remove the top by sliding to the rear, locate your main ...
Question about Maytag Washing Machines
...power to the outlet, then you will need to replace the control board. Here is the board to order.To replace the board, remove the back cover on the console, the board is located at the back of the ...
...power for sometime and see if the machine resets.If not the control panel board is a suspect. Remove the board to confirm the case , check the working of the power supply and processor.
...power plug. Remove the front panel to get access to the main board, remove and check all the connections, if there is moisture within use a dryer to warm . If the fault persists even after this then ...
Question about Bosch Washing Machines
...power to the main controller board. If so connect and check the mains voltage to the board. If the boarrd does not respond you need to remove and replace unless you are an expert to check for ...
116 questions posted
Usually answered in minutes!
1,514 Questions
200 Questions
88 Questions
45 Questions
22 Questions