Carrier XHB123D X/Y Series Heat/Cool Air Conditioner "blower motor shuts high few" Questions

...What could be the problem, as far as ticking, then stoppage? Thanks. sounds like the relay for the unit may be bad, usually if a blower motor goes it stops or has a very loud humm and only goes ...

...motor wis coming on for a few minutes then the hot ignition comes on and the gas lights. then the blower comes on then shortly after the gas cycles off and then a few minutes later it cycles back on ...

...Blower will run but condenser wont start. Disconnect High pressure switch... Compressor will start and getting cold, but for a while condenser's fan stops and compressor get hot....must turn ...

motor was replaced last winter and its been serviced 3 times. Any ideas? hi! there, blower auto shutting off and on is dependent to thermostat setting,if the thermostat acquired the temperature set it

...blower motor has burnt up.(the one inside) The unit running for a few minutes then shutting off, is due to the high pressure/temperature safeties. When you removed the panels, did you notice any fan ...

...blower simply creases. b. there is an attempt to start the heating unit (I hear the high pitch noises), then everything stops. c. there is an attempt to start the heating unit (I hear the high pitch ...

...blower motor in your furnace is running. (If the thermostat is in the "cool" position, the furnace blower should be running.) If not, check to make sure the on / off switch at the furnace is in the ...

...blower and the condenser fan. If that motor fails than the compressor may run for a short time, but will overheat and shut off. Continued operation like this will result in compressor failure. This ...

...blower and the condenser fan. If that motor fails than the compressor may run for a short time, but will overheat and shut off. Continued operation like this will result in compressor failure. This ...

...old and installed in 2010 mobile home. check your high limit switch find blower motor and unplug white wire let furnace run it should shut off when hot enough if same problem replace high limit ...