Fossil Chronograph FS4249 Watch for Men "place back" Questions

...back in place. Be careful that you do not lose the teflon seal sitting where the crystal goes and do not let any dirt or contaminants get to the face of the watch. Be sure you ask them to pressure ...

...Place your pin pusher or other similar sized object and with a small or jeweler hammer slowly and lightly hit the pin pusher down until pin comes out of opposite side , you can use tweezers or needle ...

If you don't have the back in place it will not snap back into place. Also some are a slight screw back and will snap off, but when putting them back you must kind of screw it back in place. Good luck

...back clicks into place. Try this two or three times and if you still cannot get the back to click into place, then I suggest that you take it to a Boluva dealer (which I'm sure will cost you!) but it ...

back in place and then push against a hard object like a kitchen worktop and as you push, roll the edge round until it snaps into place) but in some cases with particulaly stubborn cases you will need

the watch. Line the small indent up on the case back with the indent in the side of the watch, and push down on the case back with both thumbs with even pressure. The cover should snap back into place

!..... yoy need bottom holder and top locator one pressing jig. you take a watch and place on bottom locator and place the back cover on to watch cases then give the load slightly it will fix properly

rubber washer or the black band on the cover then try snapping it back on. I removed the washer and placed it on the back of the watch before I placed the cover on and it just snapped back on

...using the screwdriver to pry up in a couple of places. The battery is held in place with a "C" clamp which you can bend back with your fingers to pop out the old battery. Then reverse the

counter clockwise. When you feel the threads click into place, simply turn the back clockwise with your fingers to tighten. Once finger tight, once again use the needle nose pliers to tighten the back