...and then push the protectors back on the vacuum tabs. Replace the plate and screw. NOTE: I did test the vacuum to make sure it would turn on before replacing the plate and screws. GOOD LUCK! ...
...removing the sole plate from the vacuum. Doing this may allow any trapped objects to fall out without need for any further inspection: To remove the sole plate: 1. Lie the dyson on it's side so you ...
...of the brush that the belt connects to.. Put new belt on.. Put the brush back in place.. It might be a bit tough because the new belt will have a bit of tention.. Put plate cover back on and
...to put. Brush roll back into position. Reinstall bottom plate and screws. Make sure brush roll will turn before turning vacuum back on. Belt will lose elasticity and should be replaced twice a
...richads cyclonic broken belt how to fix Flip the vacuum over. Remove the cover plate. Pull the brush straight out with both hands and put new belt on. Put cover plate back on. You are ready to go. ...
...replace bottom rug plate.Looking thru hole in back,turn belt lifter knob until the hook inside picks up belt.Replace brushead,and again,turn belt lifter knob clockwise to drop belt onto
...shaft, then onto the beater bar while you replace the beater bar back into the sockets. Test your work by revolving the beater bar a bit by hand. Reinstall the cover plate. That's it! Regards!
...plate. If it's an 8955 or model with clutch to shut off the brush roll remove the rod that goes from the lever to the clutch. Look closely how the rod and brush roll are positioned in the vacuum so ...
...removing it; take your time and note how it comes out...this will make reassembly easier. Clean the debris while you have tha bar off and remove any debris thet you see in the vacuum hose area behind ...
...6 screws holding down the cover plate which has the roller brush under it. Remove cover plate and pull up on brush. Belt will come off with the brush. Put back together in reverse order with new
125 questions posted
Usually answered in minutes!
4 Questions