...slave configuration as such. There is a connector block on the back to configure other options such as spread spectrum clocking. Normal configuration is a jumper between pins 1 and 2 (all the way on ...
what is the jumper setting for wd200bb 20gb hard drive for slave Slave - Installing the new drive as the secondary drive: If installing your new Western Digital hard drive as the secondary drive on ...
Question about Western Digital Caviar Computers & Internet
...pin settings for slave mode second over from left shoud Be and S on it. Look at the outside carefully. A drives have little pictures or something that tells what pins are for what. But if not, then ...
Question about Western Digital Caviar Computers & Internet
pin set to primary and the secondary set to slave, if you're running both of these drives off of the same ribbon cable. You may have to go into your BIOS settings and check to make sure the Primary HD
pin cap in its slave position on the hard drive--for example, some drives may require the cap to be placed on the last two pins to set the drive as a slave. During the boot process you will see on the
Question about Western Digital Caviar Computers & Internet
...Slave drive. If there is a drive on the second ATA cable you need to determine the jumper setting of that drive and then set the jumper on the second hard drive to a different setting. BOTH drives on ...
...or look just around the Pins... Look for M, S, CS (Master, Slave, Cable Select) Darko, Serbia First set the jumper pin for master or slave configuration as provided in the cover of the hard
Question about Maxtor Computers & Internet
...Slave equals? :::.: pin configuration with a solo pin cover on the upper rightmost pin. Both came with a jumper across the 3rd and 4th pins on the bottom row counting from the left. There are no ...
Question about Western Digital Caviar Computers & Internet
slave drive, you will need to put the jumper pin on the 2nd column of Jumper connection from the power supply connector.. On the page 2 of the manual, you will see the correct connection of the jumper
jumper settings when used as a slave in a HP pavilion 6835 There are 3 pairs of pins: * MA(ster) * SL(ave) * C(able)S(elect) Move the jumper to connect the two 'SL' pins, if you want to use the drive ...
45 questions posted
Usually answered in minutes!
30 Questions
25 Questions