2003 Toyota Corolla "hood latches close properly" Questions

...hood latches onto. If these two items do not line up properly, it will not latch completely. what I did was, took a needle end plyers and pulled on the cable that was going into the big spring (there ...

...safety latch back first then close the hood Spray latch where it catches good with lubricant/penetrating spray (WD-40) & work cable for releasing hood until catch snaps back to proper

...hood will not close, only the safety latch engages Try spraying some penetrating oil on the latch and use a screwdriver to push the latch down as if the hood was closed. Have someone pull the release ...

hood again? lube the latch mechanism and with a screw driver try to lock the latch. if it latches then you need to loosen the latch and move it up. if it doesnt lock make sure where the cable pulls on

...latch not working properly the hood to my car will not close properly, how much would it cost to replace the hood latch? Its aprox +/- $ 25; check this part HERE. Hope this help (remember rated

latches, so they hang up and do not fully engage when slamming hood down. Clean and lubricate latch mechanism, cable release may also be issue, but shouldn't be too difficult to fix. Sometimes you are

...got pushed down it wont be able to close around the hood bar and hold it. you should hear that click when it closes. simple fix is to loosen the bolts and raise it up a little and tighten it back

Open Hood warning, and wiper blades. My 2004 Mercedes C320 is haveing some electrical issues. The wiper blades wont move unless the car is going faster than 5mph. And every time i start my car the ...

...close the hood I have 2001 convertible mustang, somehow the hood can not be completely closed. no car accident whatsoever. can anybody help me to solve this ? Make sure there are no obstuctions under ...

...properly connected at both ends. Check the hinges: The hinges that hold the hood in place may be damaged or corroded, causing the hood to stick. Inspect the hinges and lubricate them with a ...