2000 Toyota Tacoma PreRunner "coolant drain lift" Questions

Ad

...drain the engine coolant. Detach the intake air connector and disconnect the throttle body motor assembly with a socket wrench. 3 Disconnect the fuel lines and remove the fuel pressure pulsation ...

Ad

...drain the engine coolant. Detach the intake air connector and disconnect the throttle body motor assembly with a socket wrench. Disconnect the fuel lines and remove the fuel pressure pulsation damper ...

Ad

Question about Toyota Tacoma

1 Answer

...drain coolant ounce drain disconnect rad hoses and transmission cool lines use a strait head screw driver now remove the the bolts you see on top of rad usually 10mm size now lift out rad replace ...

Question about Suzuki Cars & Trucks

1 Answer

...drain the coolant into a bucket. There should be a drain on the radiator - take the radiator cap off so the coolant will drain. If there is no drain then take the lower hose off. Once all the coolant ...

...drain the coolant from the rad ,there will be a drain tap/bolt on the bottom of the rad ,be sure to us a container to collect the fluid as should'nt be left to run down a drain etc as is very ...

...coolant drain out, the rad is usually held in place by 4 bolts 2 each side loosen these off then remove top and bottom hosesfrom rad, and depending on fitting type lift rad straight up , if does'nt ...

...Drain the coolant into a clean catch pan and we you go to reuse the fluid strain it thru a cloth and will remove any trash. Good Luck HI there, You'll need something like a deep tray or basin. Place ...

Question about Toyota Tacoma

1 Answer

...Drain the engine coolant below the level of the ECT sensor. Refer to Draining and Filling Cooling System in Cooling System. Lower the vehicle. Disconnect the electrical connector from the ECT ...

...) Remove the coolant pressure cap. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information. Place a drain pan under the drain ****. Open the radiator drain

...DRAIN THE Coolant !! usually take the cooling fan off the the rad unbolts and lift it out . of course hoses and coolant are already drained into clean bucket a large piece of card board will help ...

Not finding what you are looking for?
2000 Toyota Tacoma PreRunner Logo

306 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...