2000 Toyota Corolla "39 pull key ignition" Questions

...key off in my ignition and can't remove lodged piece. Have replacement but can't turn old ignition to 'acc' to unlock. Are there any other methods for removing/replacing old ignition? ...

...39;t turn off after I turn the car off and even pull the key out of the ignition. In fact, once I pull the key out, I get the alarm indicator going off. So I don't run my new battery down, ...

...key the ignition lights are on in dash, and when i try to start the car it wont start. i think i did some thing wrong with wiring or no any idea.. my dear friend since you know that really did ...

...39;t start, distributor clicking when ignition turns on and RPM Gage flickers First you have to determine weather you have a FUEL problem or (ELECTRICAL)Spark problem ?? Pull the coil wire off or a ...

...39;s how to check the injector circuit.Pull off one injector connector and with a testlight grounded on the engine, turn key to on. Probe the terminals of the injector connector. One of the terminals ...

...39;s how to replace the ignition switch in your car.Instructions:1.Disconnect the negative battery cable from the terminal on the battery. Remove the upper and lower steering column covers by ...

...39;s but the earlier model is different. The special tool is a pen,there are two ways there is a openining next to the key .push the pen next to the opening of the key turn the ignition key to 0 ...

...39;ll be able to pull it out of the steering column. Note that this only pulls out the lock tumbler; the actual ignition switch will still be left in place, permitting you to start the car with, say, ...

...39;ll be able to pull it out of the steering column. Note that this only pulls out the lock tumbler; the actual ignition switch will still be left in place, permitting you to start the car with, say, ...

39;s manual):1. Start with the key out of the ignition, drivers door is open all others closed and     drivers door is unlocked.2. Perform these steps within 5 seconds. &