1998 Toyota Tacoma "clutch change" Questions

...change blade not the clutch assembly. You must never have opened the hood & even looked or ever worked on a vehicle Appears all the motor options have 4 studs & 4 nuts holding the fan clutch ...

change clutch I have a 4x4 manual drive tacoma. Is my clutch bad? It work when 4wheel drive is on, but not when it is in regular 2wd. Car goes into gear, but does not advance when you release the ...

...change a clutch master cylinder on a 2006 toyota tacoma need help on how to change clutch master cylinder remove line from the side of clutch master cylinder two bolts or nuts on firewall inside ...

...change gears, and then would not engage. The clutch pedal also lost all pressure. I went ahead and put a slave cylinder on hoping that was the problem. After installing the slave and bleeding the ...

clutch it wont allow me to change gears and it sounds like an air pump Hi, That sounds like you have a problem in the pressure plate! Go to the nearest garage and pull down the transmission to replace

...look like this thats the release bearing...... i would also change the pilot if you end up pulling the tranny and hey while your in there you may as well put a new clutch in it too -jeff please ...

...clutch of a 1998 toyota tacoma sr5 4x4 v6 If you want to change the "Remove clucht trasmision bars front and rear, remove the cylinder in the booth attendant said you have to remove the gear-change ...

...normally use. I thought these diffies used 130 weight? Does it say in your manual? If you have clutches in there,you will need to install new ones,seeing as how the fluid change and additive

...clutch could be a problem. It is not real hard to change out. It should be pretty self explanatory if you look at it. They are not controlled by any wires or anything. Your water pump is driven by ...

IS IT HARD TO CHANGE THE CLUTCH ON A 96 TOYOTA TACOMA on a scale of 1-10 with 10 being the hardest it is a 7, u will need allot of equipment and a huge selection of tools