...make sure the pulley bolt is tight then check the pulley for being bent. if these 2 things are good then you may have a bent crankshaft at the pulley end or worn crank bearing causing it to
...crank pulley need replaced or just the pulley? Check all of the accessories that run off the belt. some may have loose or bent pulleys or the acessory itself may have come loose. Be careful to route ...
Question about Toyota Corolla
...crank pulley and off water pump/fan pulley. The wp/fan pulley does seem to wobble and when checked moves side to side. There was a squealing sound prior to belt being replaced. Belt just slipped off ...
...pulley on the crank is loose and wobbles and makes a noise until the engine warms up and suddenly the pulley runs straight, and the noise stops what? how? why? How is the inner pulley attached to the ...
crank pulley. makes a noise. tighten, still wobbles, no noise, lasts for a day then noise back. 94 -- 3.1 td. cheers. steve. The key way has probably wallowed out. Replace the harmonic balance pulley.
...crank pulley squealing on acceleration--- lost timing mark---wobbly pulley ---rubber coming out from between the pulley and the hub-- steps in the sides of the pulley if V belt--- worn out teeth if ...
...is doing it. Crankshaft Damper Pulley-- gone bad,replace it Some engines have a bolt in the center of the crank pulley that may need tightened. You also could have a harmonic nalancer coming ...
Question about Cars & Trucks
pulley wobble on front of 1991 Mazda MX5 Miata engine with short nose crank Is it less expensive to replace the motor (and what will fit?) than purchase a long nose crank and all the extra stuff ...
Question about Cars & Trucks
...pulley to wobble if it just has the 1 bolt in the center of it holding it in 2001 dodge 3500 dually Year/make/model?? Check to see if bolt is loose. Some crank pulleys have a rubber insert that can ...
...crank pulley is hard to spin by hand see if wobble by hand, if one of those pulleys has excessive movement that was the problem, if all of the are tight then just adjust the belt tension, good luck ...
899 questions posted
Usually answered in minutes!
1,231 Questions
1,240 Questions
1,236 Questions
819 Questions
767 Questions