1994 Toyota Pickup "shifter bushing" Questions

shifter bushing that is located in the shifter housing that is rubber and it will either be gone or worn out and also i would replace the plastic ball that goes onto the end of the shifter...to access

loose stick shift manual transmission There is a white plastic bushing at the bottom of the shifter, its possibly worn. Remove the shifter boot and shifter to inspect/replace.

or 2nd) are a little deeper than the shifter bushing. I'm not a transmission specialist so anything any deeper went too the guy 2 bays down. Most mechanic work is just common sense and a LACK of force

...The cause is from a worn bushing at the bottom of the shifter. You will need to have the bushing replaced in order to correct the problem. The part will most likely have to come form a

...beyond 1st gear and will move all around! Easy fix! Remove boot, take out four screws, shifter pops up, replace bushing! Keep it in neutral before starting. Plastic bushes under the lever worn

...s full you proablly need to rebuild it Yes you can remove the shifter Boot & check that bushing first". Its maybe $5 bucks. Check the linkage. Then after all that, hopefully it will go another ...

bushing. is that true? Pull the shifter out and look, as there is a plastic "ball" at the end that may be worn out. Take off the shift boot inside the cab, and notice a collar around the shifter, push

...is. i have noticed third gear does not go in as far as the other gears do. remove your shifter and check the plastic bushing at the bottom tip of it. Replace if worn, if ok it may be a trans

...shifter bushing wear or just general wear on tte trans. It can usually be remedied at least temporarily by popping the shifter top off the trans and resetting the forks all back to nuetral and then ...

...plate,throw out bearing,and pilot bearing for sure then it is a smart thing to replace shifter bushings, and even the rear main seal and be sure to have the flywheel machined ...please ...