Question about Toyota Previa
...bolts (actually 6mm - with 10mm head) are too long after years of pulling the gasket tight. a couple washers under each will get you on the 'road to recovery' with this issue. 2) ...
Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque. Foot pounds
...bolts 9-10 torqued to 40Nm (30ft/lb) then (either engine) give each an additional 90° (¼) turn it's best to do the tightening in stages, you don't want to go completely tight on the first ...
reason of water in engine oil. For 4Y engine the reason is it water mix with due to burn head gasket you mush have to replace the head gasket and torque or tight head bolt to a correct torque
Question about Toyota Previa
...bolts Gaylene Green, If you already had a heating issue... just skip over all this meaningless RE-Torque "STUFF" If there was no overheating before this procedure... I would suggest either the WRONG ...
...bolts, finger-tight. With an accurate torque wrench, tighten the bolts gradually, in sequence, working from the center outwards. Final torque should be 33 ft. lbs. (45 Nm), plus an additional 90 ...
Question about Kia Cars & Trucks
tight, half torque and full torque. Better to do the job right, do it once, replace the gasket. The torque specifications for the valve cover bolts on a 2007 Kia Spectra are: For the M6 bolts: 4.4 - 5
...bolts not only hold the head on, but they compress a gasket with the right pressure to make the gasket perform correctly. Too loose and the gasket will not seal, too tight, and the gasket will be ...
...bolts don't stretch so much that the head gasket can't be tight against the head and block. it's part of the torque procedure on some engines to stretch the bolts but not true on the 2 liter DOHC kia ...
...on a orginal 305 in my 83 seirra. got the heads sitting back on with the new gaskets. bolts are hand tight.I have a diagram of the sequence. I need the torque specs for the bolts. 60-70 Foot ...
362 questions posted
Usually answered in minutes!
216 Questions
229 Questions
195 Questions
156 Questions
116 Questions