1997 Lincoln Town Car "35 engage switch" Questions

...engage...was told climate control module is faulty not neccessarly true there could be several reasons for the a/c clutch not to ingage. 1 the clutch relay is bad(it is located in the junction box ...

...speedo,ECM auto transmission brake switch, VSS sensor , tacho,ECM they will not engage under a set road speed or rpm requirement which is around the 25mph or 35 kph and will not engage ...

2002 Mitsubishi pajero code 35 F/W engage switch. centre diff light flashes, Where is this switch the switch is the 4x4 switch

...4hi to 2hi while driving less than 35-40 mph....but to switch from 4hi to 4lo you have to be doing less than 5 mph...if it does not engage try shifting thru the gears then hitting the 4lo button ...

...cut off switch is disconnecting the clutch when the pressure goes down. Pressure should be around 35 pounds on suction line at about 3000 rpm. How you know freon is good?Must be 30 plus or too

...Engage Parking Break Take ignition key and put into shift lock release slot (near gear shift) Push down on key and at same time MOVE gear shift to neutral. Remove key, start car as normal and ...

...35 PSI, but with the switch installed and the AC on, still the compressor won't turn (clutch won't engage) unless I bypass the cycling switch, so what's the faulty part? thanks for any input. The low ...

...35 psi which sounds like normal range. So I am stumped. Any ideas? AC will not run unless the clutch is energized. You got it to engage by jumping power line. Check to see if there is a relay in the ...

engage. Made a few phone calls. Opened hood and checked the serpentine belt. Tried to start it again, bingo! Drove 35 more miles, no problem. Got gas. Started fine. Drove home. Still runs good, starts

...35-45 on low gage, and 175-225 on the high gage. And make darn sure the cooling fan comes on! A/C clutch wont get power if there is not enough(low pressure switch) or too much(high pressure switch), ...