1989 Jaguar XJ6 "lift spare wheel" Questions

...lift out the ply cover on the spare wheel, and the wheel, between the wheel and the rear is a ply and steel filler panel, held in by screwa, unscrew these and the pump (s) is under there. Fuel Pump ...

in n america) lift out the ply cover on the spare wheel, and the wheel, between the wheel and the rear is a ply and steel filler panel, held in by screws, unscrew these and the pump (s) is under there

lift the boot floor out and there is a fuel filter bolted in beside the spare wheel. Have someone turn the ING on while you listen to the fuel filter an you here it working. Try changing tanks and try

...spare wheel mounting bracket and remove bracket. 3- Remove tank upper insulation pad. 4- Disconnect fuel pump harness from evaporative loss flange connection 5- Release harness attached to tank ...

...spare wheel off a renault clio Hi Open the tailgate, lift the trunk carpet, to the right of the lock catch, you will see a nut. Fit on the wheel brace, and wind anti clockwise and the spare should ...

...lift carrier and move hook off you can now lower carrier/spare wheel off reinstall is reverse proceedure now a word of advice? lubricate the threaded lowering bolt b4 refit of carrier and do not run ...

...spare tire will not fully raise Sometimes the wheel is shaped differently on one side than the other. It may have to be installed upside down or rightside up to fully crank up in position. Your spare ...

Lift up the table or cover on spare tire and the plastic housing for the spare tire then lifts up (by removing some simple pins) and the jack is tucked underneath (next to bumper, but on the inside of

...spare wheel lowering bar sitting in 2 clips. Take that bar to the back of the car and lift the tailgate. Just to the right of the latch that locks the tailgate in place is a hole to suit the bar. ...

...it a bit, look underneath the vehicle and the wheel will be lower, you can usually lift the rack up and unhook the bolt to lower the rack to slide the spare out. do the reverse when replacing the ...