2004 Lincoln Navigator "rod fuse location" Questions

...fuse and scrub the contacts with a brass brush untill clean. To keep it from corroding in the future apply some dieletric grease to the contacts and plug it back in. hope that helps, Rich. Lincoln ...

...Fuse 109 (50A). Air compressor assembly. Circuitry. Air suspension relay. Go To Pinpoint Test P . ---------------------------------------------------------------------------- The system consists of ...

...fuse 111 (50A) Loose, corroded, or disconnected connectors Air suspension service switch is in the OFF position Damaged solenoid valve(s) ------------------------- I fthis does not help, the dealer ...

...fuse box it is located above it about 10" it is round and silver. Use rod to push off clamp. Now use hanger to retrieve flasher unclasp and install new flasher. Reinstall flasher and clip under dash ...

...come on but the brake lites dont Ck the fuse first it located in the fuse box on the driver side inside the truck if good then ck the brake light switch located on the brake pedal rod under the ...

...fuse out. You can also remove the switch to access the fuses. To remove the switch. locate the release button on the switch. Press the button and pull the light switch rod out of the switch. Remove ...

fuse.if good check your relay fuel pump relay located beside steering rod under the dash board, it might be defective also.have a nice day rate my fix thanks a lot. Is the fuel pump running. Check for

if blown. If the fuse is not blown, check the bulbs themselves. If the bulbs are good, then the next step is to replace the brake light switch located under steering column attached to brake pedal rod

...fuse is ok it's most likely the switch itself. That is buried under the dash and is not easily accessible, but if you follow the brake pedal up under the dash at the top there is a rod that goes to ...

...the entire fuse panel? Not an easy job, but unless you can locate a wrecked car for a donor part, I suppose you could buy a generic hot rod panel and patch it in. Why are you needing to do this?