2000 Hyundai Accent "timing setting 1" Questions

...1 tooth, how can I tell? How If I get an error code of 0340 after my timing belt replacement on a 2005 Hyudai Accent, my cam could be off by 1 tooth. if my cam is off by 1 tooth, how can I tell? How ...

...timing belt cover. make sure cylinder #1 is set at TDC. making sure all components are properly aligned and loosen pensioner to remove old timing belt. Install new timing belt. Tension belt, ensure ...

...on how to get everything set. You have to set #1 TDC, line the timing gear marks up according to the vehicle requirement and have the valves in the Correct position or your going to damage

...timing marks you req are as follows the crank cog has a dot indent on it and it has to align with same mark on the engine front at approx 12-30 pm position? it is clearly visible then the cam cog you ...

Why does the gas pump cut off every 1/2 to 1 gallon on my 2003 Hyundai Accent, at slow pump even when the tank is nearly empty. It doesn't matter what station I go to. Why can't I set the auto-fill on

installing new brake pads on 2000 hyundai Accent GL how do i install new brake pads on 2000 Accent GL REMOVAL 1.Remove the lower bolt and lift the caliper assembly up and secure it with a wire or some

...1- disconnect battery 2- remove valve cover 3- remove timing cover 4- set engine on top dead center #1cylinder 5- remove timing belt ( mark direction if re-using belt) 6- remove camshaft & rocker ...

...1 check and recheck the belt timing,cam to cam timing,replaced cam sensor Three times,ecm once, absolutely baffled; note one other test i didnt mention ,we pulled fuses w koeo while monitering the ...

...timing belt and tensioner cost £50 here in uk ? it is not too difficult diy job approx 2hours the engine must 1st be set to TDC number 1 firing then at this setting the cam cog mark is a hole ...

...setting 1 and 2 I hardly feel anything, Only at 3 do I feel some air blowing out. I can hear the motor blowing stronger if I increase the settings, so I'm wondering if it could be clogged somewhere. ...