Hyundai Motor 1998 Accent "98 1 timing" Questions

firing order 98 hyundai accent 1342 no. 1 at timing belt side. Regards Phillip

...98 hyundai accent sohc First you need to find out if this is a "safe" engine, a few are but most bend some valve when the belt goes (you could try turning gently by hand using the alternator belt) ...

...98 sputters during acceleration and check engine light starts to flash I've recently changed the plugs and cleaned out the intake but it still does and run runs just fine as long as i'm not ...

98 elantra 2.0 1.8 l... i need timing marks for 98 elantra 2.0 1.8 l the camshaft is the dot on the sprocket there is a small mark behind it on the cover 12 oclock the crank there is a mark on it look

...98 dodge neon 11= Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine ...

...98 Hi: 1st thing to do is pull #1 Spark Plug AND before you Crank The Engine PULL COIL WIRE so your car does'nt Start During Your ommpression Test.Once you have commpression coming out #1 Spark ...

...sensor and the time to clean the throttle body, on a 98 jeep cherokee sport 6 cylinder,4 liter? thanks glenn Its about 1/2 hour job max on the sensor.To replace the t/body is a 1 hour

...98 malibue v 6 here you go Fig. Align the timing mark on the crank sprocket (2) to the mark on the bottom of the timing chain damper (1) and the timing mark on the cam gear (4) to the mark on the top ...

98 toyota tacoma v6 4wd 3.4l eng. I took the timing belt off without marking the pulleys, and looking in the manual can i just line of the marks on the pulley with the marks on the block? and by doing

...98 cavalier 2.2 1998 Chevrolet Cavalier 2.2L SFI OHV 4cyl Fig. 1: The timing marks on the sprockets should be in alignment. If not, turn the crankshaft until the marks are aligned Fig. 2: The timing ...