1997 Hyundai Accent "tighten inner drum washer" Questions

inner wheel bearing from the spindle. To install: Install the drum on the spindle. Install the outer wheel bearing and washer. Tighten the locknut to 108-145 ft. lbs. (150-200 Nm). Turn the brake drum

...inner one in the drum and tap in the grease seal in place, but the drum back on and install the outer bearing on the spindle, the wash, nut, cotter pin and dust cover. Tighten the nut snug and turn ...

...inner bearing. Install is the reverse procedure. Just make sure you pack the bearings you can do this by putting a little clump of bearing grease in the palm of your hand and pushing the bearing into ...

...tighten 2-3 turns grab drum by sides and pull towards you this should remove drum leaving inner bearing/seal on shaft to replace reverse procedure making sure to pack new bearings w/grease(take drum ...

...inner bearing is first to put in,then the seal.Tap the seal in with a hammer(also cup side in).Take the drum(hub)and slide it back on go over the the spindle,by twisting and pushing lightly,it has to ...

...inner wheel bearing. Install a new grease seal. Install the drum to the spindle. Lubricate and install the outer wheel bearing, washer and nut. Adjust the bearing preload following the procedure ...

...inner bearing will be installed at this point (it goes on it's race before you install the seal). Carefully put the drum back on the spindle being careful not to damage rubber on seal and install ...

...inner bearing will be installed at this point (it goes on it's race before you install the seal).  Carefully put the drum back on the spindle being careful not to damage rubber on seal and ...

...inner seal is damaged while removing the outer race replace with new seal.) 7. Clean all contaminated grease from outer bearing cavity of the hub. 8. Install a new outer race into the hub using an ...

...drum. pack the inner bearing with clean wheel bearing grease and fit it into inner race press in a new axle seal into place by hand. lightly coat the stub axle with grease and install the drum or ...