Question about Land Rover Range Rover
...engine off and key removed, the fuse islocated on right hand boot compartment clean it then replace, startup then drive. Fuse box tends to get some humidity damp over time. This completely solved our ...
Check Fuel Cap" keeps coming back. To clear this message, I keep take the gas cap off and re-install it back and drive for few miles then the message go away but it will pop up couple hours later
...check engine light came on. We had the code read, and its was the "Air Flow Meter" which was changed on 10/16/09. The loud muffaled noise still persist on exceleration. Like the car is hesitating but ...
check engine light came on and had the codes p2107 and p2110 can I just earse the codes and be fine or did I cause some damage??? Probably you can erase codes and if they don't come back (assuming the
...FIXD is ... Get your FIXD sensor today! Unlike other OBD2 sensors, FIXD provides detailed, easy-to ... FIXD Sensor - The Car Care ... /Sensor. Check engine light? Clear it fast and avoid getting
Question about BMW Cars & Trucks
...CLEAR, look and check the belt is moving smoothly on all the pulleys you can see and not sliding from side to side. Check the dash board for any warning lights or messages and turn the engine off. ...
Question about Cadillac Cars & Trucks
...check for stored fault history. Do you know what electronic throttle control ? ENGINE POWER REDUCED Throttle Actuator Control (TAC) System Description for the 3.6L engine, Throttle Actuator Control ...
...engine management light comes on. My local garage, has checked everything, put signals into the sspeedometer,checked the speed generator on an osciliscope together with normal continuity checks, but ...
Question about Cars & Trucks
...check circuit continuity and resistance between the switch and the PCM. The mechanic should make sure to disconnect any related control modules to prevent memory loss. Clear the code and test the ...
engine light is on this is a service feature or something needs attention ....check all the fluid levels and belts etc..to get the light out disconnect the + positive cable to the battery fro a few ...
567 questions posted
Usually answered in minutes!
202 Questions
166 Questions
166 Questions
146 Questions
112 Questions