...idle, dropping as load increases; for LH 2.4.2 system output 7 volt at idle etc; testing between terminals)33 and 17 at disconnected LH connector; possible problem with MAF. Hope this helps Saabreur ...
Question about Hyundai Cars & Trucks
...idle is 850-900 and should not drop below 800 in drive as the ECM should be adjusting for the drive load when in gear take it in to an accredited service shop that works on your make of vehicle and ...
...below 500 and my car wants to cut off or it does stop, when I start it up again it runs just fine with no problems. What could this be. Here are some of the causes of surges, stalls at stops, slow ...
...idle truck stalls out sometimes 2003 5.3l gmc sierra has had an intermitent problem of stalling out. First thing done was plugs and wires. Second check air flow and clean out filter area of dirt and ...
...below 500 and seems a bit unstable, only when decelerating. This does not happen until it is warmed up. Runs perfect when engine is cold. Any help for poor me? suspect distributer needs replacing. ...
...500 rpm and chugs like its starved for fuel. When I give it gas, it will rev up smoothly, but then it looses it and the rpm drops down again. If I hold the gas down, it will just rev up and down in 5 ...
...idle rough almost immediately and drop below 500rpm as it does this. I've gotten multiple misfire codes. And a turbo under boost code all seemingly on cyl bank 1. Which is passenger side of car. And ...
...idle not reached, vacuum leak found26 Peak injector circuit voltage has not been reached (need to check computer signals, voltage reg, injectors) (SEE NOTE #4 BELOW)27 Injector circuit isn't ...
59 questions posted
Usually answered in minutes!
367 Questions
320 Questions
291 Questions
155 Questions
123 Questions