1996 Land Rover Discovery "alternator belt" Questions

...the pulleys in the diagram except the alternator. Use the same step to install belt on alternator pulley which is always the last pulley to fit belt onto. Then reverse procedure and tighten all

...alternator belt on a 1993 land rover discovery, the belt is behind another belt and im not sure what the other belt drives WEll, sorry, but the impeding belt would need to be removed first. I suggest ...

...belt tentioner, alternator, battery connections or wiring could be causing your problem. Check with volt meter, not running approximately 12.5v at battery , start engine, should have approximately ...

...belt. Disconnect leads from rear of alternator (make a note of which ones go where) Remove securing bolt from bottom of alternator. Remove long through bolt from top fixing and withdraw alternator. ...

...alternator water pump and steering pump are all ok . what can we try next Hi: Often the reason a belt is failing is due to a component being out of alignment, or the tensioner pulley failing. Check ...

...alternator belt is well in tension, there is a tensioner, is the arm that move the pulley, you may need to use a rubber hammer to put it well in tension. Check also the alternator wirings and the ...

I have a 2001 landrover discovery series 2 and my alternator keep's going bad if its bad bearings its cos the belts too tight.if its electrical then its faulty alternators.

battery surge surging lights battery drain? have the output of the alternator checked as the surge is from the alternator regulator . Check condition and tension of the drive belt

...remove belt from 2001 land rover how to remove alternator belt from 2001 land rover You have to release tension at the tensioner pulley. Lisle tools makes a good wrench for this as clearance is

...belt is not tight, or it is slick then that will cause the alternator not to spin fast enough to send out the correct voltage. I am assuming that they tested it under a load too. Ground connections ...