02 kia oil light came on oil was loww engine shut down will not start engine cranks but will not restart after putting oil in You have probably spun a rod bearing. These engines do not like running ...
...crank shaft balance belt must change same time, you set all mark the same positions, you can see all clear marked if you had OBD2 scanner is helpful to read all faulty codes if you do it your self ...
...crank shaft doel pin to twelve 0 clock position. Top Dead Center (TDC) . There is a mark on the timing cover just above the crankshaft which has TDC and the degrees BTDC (before top dead center). But ...
crank shaft position sensor. still turns over but wont start Is there compression int he cylinders? pull a plug and put your finger in the hole, and have someone try to crank the engine. If the engine
...crank shaft cencors and there compression. No spark getting to the spark plugs now. Car will not start. you need to correct the timing belt, remove the appropriate parts and time the engine back to ...
crankshaft position sensor the crank shaft position sensor is located under the lower timing cover on the block
lining cam shaft sprockets with crank timing gears there is a mark like this(0) on both-bring them in line with each other and you have it.
...crank shaft positioning sensor. If you have a somewhat mechanical mind or a good friend you can do it yourself. I ordered the part on Ebay with my vin # and got the part. Helpful hint is to make sure ...
crank shaft position sensor, because someone had replace the timing belt and it rubbed threw one of the wires. HelloThe engine in this cars drive train is fully electronically controlled by a computer
crank shaft reading changed crankshaft sensor the one by timming belt and also changed ECM relay but still have same problem seems this is common from my research but havent found the cure any one can
1,592 questions posted
Usually answered in minutes!
370 Questions
337 Questions
285 Questions
277 Questions
281 Questions