...intake manifold Intake manifold using new gaskets. Torque the bolts, in sequence, to 105 inch lbs. (12 Nm)... Fig. Intake manifold torque sequence-3.7 & 4.7L engines Hope this help (remember ...
intake manifold. An O-ring seals the sensor to the intake manifold. (click over image for zoom) Disconnect electrical connector at sensor. Clean area around MAP sensor. Remove 2 sensor mounting bolts.
...intake and exhaust manifold bolts front front to back. You will see that some are exhaust manifold bolts only and the other share responsibilities of holding the exhaust and intake to the heads. ...
intake manifold and clean surfaces. Inspect manifold gasket condition. Gaskets can be re-used, if not damaged. Position new gasket in seal channel and press lightly in-place. Repeat procedure for each
Question about Kia Sephia
...intake manifold on a 1995 grand cherokee V8 5.2 I broke an EZ out in the thermostat housing hole. I can't get it out. Please watch the video. 98 Grand Cherokee 5 2 V8 318 MOPAR M1 Intake Manifold ...
...Intake manifold) gasket is worn maybe you are missing a bolt or you may have a cracked manifold. it usually means an intake valve isn't sealing. check to make sure the timing belt is okay. if it is, ...
Question about Jeep Cars & Trucks
...intake manifold. Remove the wiring harness from the intake. Remove the throttle body support bracket. Disconnect the electronic throttle control and manifold flow control valve electrical connectors. ...
4cylender jeep and what all would you have to change. You would need to get a custom inlet manifold as the head intake differs between efi and carb models so a carb manifold won't bolt straight on
...intake manifold is the common culprit for this. It may look like it is flush to the block, but it isnt and is causing a huge vaccum leak. There are two locating dowel pins that the ...
655 questions posted
Usually answered in minutes!
646 Questions
311 Questions
187 Questions
127 Questions
85 Questions