1999 Kia Sportage "back body mount" Questions

...back door. Seems permanently locked and keys and keyless lock/unlock have no effect. Rear window latch works to open window. Not sure about your car, but on my Chrysler mini van the same problem ...

...back at power brake booster there is a cover 2 torex screws holding this cover keeping this vacuum line in channel support Remove. Unlock this Vacuum line from power steering reservoir bottle and ...

...body. Camshaft pulley alignment marks Align marks on camshaft pulleys with alignment marks on seal plate. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft ...

...following:Poor mating of the connector halves or a terminal not fully seated in the connector body (backed out).Improperly formed or damaged terminals. Carefully reformed or replaced all connector ...

...to the antenna hole in the panel of the car, slide the antenna from inside of the cars panel till it is fitting back into the rubber body mount. Refit all support brackets, ground wire and coax

...back fires thru the throttle body This is only a suggestion but I had a similar problem. I have a 1987 Camaro Iroc z fuel injected. I had a similar problem with the car back firing through the ...

...back of the throttle body. You will have to remove the plastic throttle body cover to see it Don't know what engine you have for sure, but it is should be found mounted to the side of the throttle ...

...body These two support the engine L to R. There are also mount(s) to stop the engine rolling back and forth. These are attached to car front and rear sides of the engine block or on the transmission ...

Jack up the body slightly and remove the 3 inch spacers one at a time from between the body and the frame. Then let the body back down on the the stock rubber mount and put a stock length bolt back in

... One at the front, passenger side of car and one on the back of the transmission. There is also a dogbone mount fron the front top of the engine to the ...