1994 Jaguar XJ6 "vcm fault" Questions

VCM fuel 37 fail 37 reading what does tjhis mean? fuelfail37 is a egr problem it should not be there on your aj6 engined car has its not got a egr valve? on a uk spec it has not got one. car in the us

VCM fault coed fail 24 Generally speaking if a EFI car wont start but will "turn over" there are many points in the fuel system that could be hindering the process. I would start with the fuel filter.

VCM. Fuel pump hums for 1 second. What could be the cause ???????? FF22 is Fuel Pump Drive failure ECU looks for sognal to the fuel pump relay. found in jaguar-forum: "I'm 99% sure that you have a bad

VCM fault), Engine crank but cannot start. The problem happened after replacing the speed sensor(Flywheel sensor) which has been damaged and we have already replaced it with new one. Fault on OBD are:

...fault codes may be erased from memory at any time by removing power from the VCM for at least 30 seconds. It may be necessary to clear stored codes during diagnosis to check for any recurrence during ...

...or finds corrupt data from the EEPROM. GM recommends testing/replacement of the VCM/PCM using required equipment by a qualified technician for this type of VCM/PCM memory performance fault

...than that, the only advice I have for you is to scan your VCM for possible fault codes to help pinpoint the cause.Please note that most generic OBD code readers CANNOT perform this

...fault". After being checked,we changed the battery because it had only 12.4V instead of 12.7V. But after being replaced,error still exist and can't be cleared. We used SDD JLRv134 and VCM Rotunda to ...

Break fault light this means there have some problems in your brake system.__________vcm ids at http://www.careucar.com/wholesale/ford-rotunda-dealer-ids-vcm-for-ford-mazda-jagua-and-land-rover.html

VCM turns ON the MIL after 2 consecutive driving cycles with the fault active. Conditions for Clearing the MIL/DTC * The Control Module turns OFF the MIL after X trips when the test has Run and Passed