Question about Hyundai Elantra
bleed the brakes ending at the shortest. There should not be a problem if you have a helper to work the brake pedal for you as you open the bleed screws in turn Because you disconnected the brake hose
replaced caliper but im having problems bleeding brakes i replaced the rightside caliper but now there is no brake fluid going to the caliper bleed left rear caliper then retry..
brakes r mushy,i changed the master cylinder better for a week then mushy again then good again for about a week,have been doing this for 6 weeks,fluid doesnt go down,cant find no leaks, but air comes
Question about Hyundai Elantra
...would cause there to be no brakes what so ever even after replacing all the broken brake lines and bleeding them all on a 2003 Hyundai elantra? I have replaced all broken or rotten lines on a 2003 ...
brakes then fully reassemble then b4 fitting wheel? bleed the brakee caliper a couple of pumps should expel dirty fluid then fit wheel carry out same proceedure on other brake assy as above fully then
...happens when brake pedal goes to floor on 2005 hyundai elantra You are probably out of brake fluid. Check level and then bleed brakes. Either that or you have a brake in your break lines
Hyundai Elantra brake pedal is very soft and fails to stop in one go and requires pumping to stop might be low on brake fluid or need to bleed brakes
Question about Hyundai Elantra
...lower hose fitting with new hose.Tighten union. replace c clip and bleed brakes at nipple on callipers until all air out of lines. Job done road test for hard pedal repeat bleeding as
Question about Hyundai Elantra
...this and I still have nothing... check brake fluid level --if good- air in system or in need of new braakes if brakes are good than need to bleed air need out check for leak if no leak bleed ...
974 questions posted
Usually answered in minutes!
1,180 Questions
1,029 Questions
508 Questions
493 Questions
443 Questions