2000 Land Rover Discovery "wire lamp holder" Questions

no tail or side lites-turns work & stop lites no tail or side lites-head lamps work-turns work & stop lites work-l turn very fast-r turn normal?-chd fuses all ok Sounds like you have bad ...

wire that goes to the brake switch, if not , then re check the fuses, if they are ok, then you need to go to an auto electrician , as the problem is in the electrical installation.If you do have power

...wire to the body/chassis connection to ensure a good earth , check for power to the indicater lamp , the bulb holders may be the problem , this is a problem that requires patience as can be hard to ...

...wire a cooker hood lamp holder. The wires look like push in fittings, but I can't see how to release the old wires First off turn the power to the unit OFF. On the side where the wires go in there is ...

...wire. You may have a bad connection in the wiring. With the bulb removed take a look inside the bulbholder to ensure it is clean and the contacts are bright and brassy or silvery. Best to use a test ...

...lamp to the bulbs these often corrode till theres nothing left replace them if they are like this also check you have got the right bulbs in the bulb holders they often get the wrong ones fitted ...

...lamp positive wire is shorted to ground. Possible causes: - Reverse lamp switch is shorted. - Short circuit in wiring. - One of the bulb or bulb holder is shorted to ground. - Fuse is

...burning when powering on when the lamp is burnt out? no-- if the lamp is burnt out there is no current flow to make it get hot to smell that may be from a short in the lamp holder where the wires ...

...screws. Pull the lamp assembly from the truck and disconnect the wiring. Remove the bulb holder fasteners. Remove the bulb(s) from the lamp. Install the bulb, connect the wiring and install the

...lamp to 1 relay) connect positve wire from battery termial to relay (each relay seperate wire) connect negative wire from cars body to relay (each relay seperate wire) 4.) connect Out from relay to ...