Question about Land Rover Discovery
...i put gas i the intake and nothing so i cheked for spark and nothing it has new coils wires and plugs What's your problem? The ignition system is controlled by the ECM. Check power at
Question about Land Rover Discovery
...plug wire set CAUTION Spark plug wires must be connected to the proper ignition coil terminal. Mark spark plug wire locations before removing them. The accelerator cable bracket nut The accelerator ...
...plug wire boots. Attach the spark plug wires to their proper terminals on the coil and make sure the boots are firmly seated so that the locking tabs engage. Attach the engine control wiring ...
...location where is ignition coil D located on a 4cyl. 05 ford escape? Follow the plug wires back to the coil. This engine does not use "coil on plug" so there is only one coil. If there is a cover on ...
...plug wires away from the spark plugs. The coil packs are on top of the ignition module. The coil packs have two terminals each and will have two spark plug wires attached to each coil pack. There are ...
...FRONT NUMBERS 5 6 4 THATS YOUR COIL PACK PLUG WIRES LOCATION. LIKE I SAY 5 6 4 IS PLUGS WIRES LOCATION FACING YOU AND BACK NUMBERS 1 2 3 PLUG WIRES LOCATION ON COIL PACK. FIRING ORDER IS 1 4 2 5 3 ...
...Plug (COP) ignition. The spark plugs are located under the ignition coils. It is not recommended that you try to replace the spark plugs unless you have access to compressed air to blow dirt and ...
Question about Land Rover Discovery
location of ignition control module 2001 cadilac deville Ignition Coils/Modules The electronic ignition system uses an individual ignition coil for each cylinder. There are two separate ignition ...
Question about Ford Cars & Trucks
...coil on my 2001 ford taurus with a 3.0 liter; dohc engine? where is the ignition coil located on my vehicle? Follow one of the plug wires from spark plug back to thr IGNITION COIL!.. There it
location ; behind the intake manifold. If you follow your plug wires, you'll find two coil "blocks" on the rear side of your manifold. I say the job is difficult, because there is not a lot of room to
281 questions posted
Usually answered in minutes!
318 Questions
325 Questions
233 Questions
215 Questions
235 Questions