2000 Land Rover Discovery "engine stalled 55 mph" Questions

...stalls and buck 55 to 65 mph engine stalls and bucks 55 to 65 mph trans fluid flush and change filter, USE Chrysler ATF +4 only!! if that doesn't help, trans rebuild, Any check engine light,

...55 mph and if the engine smoothes out then replace the EGR Valve.If the engine does'nt smooth out at 55 mph then check the fuel pressure.It should be 41-47 psi with the key on and engine

ENGINE STALLING ENGINE IS STALLING AT LOW IDLE WHILE DRIVING Sounds like it could be a faulty EGR Valve.Try this,get the car up to 55 mph and if the engine smoothes out then replace the EGR Valve.

...engine light comes on if i go over 55 it starts to stall you need to have the computer scanned for codes .check the fuel pressure at 55 mph.check the exhaust for restiction,bent,clogged convertor ...

...stalled and will not start now. Have checked the alternator and battery, both were good. What else could be wrong? Hi,this could be a bad timing belt , you can check it by removing the oil cap and ...

...55 sometimes, is the check engine light on? You can sometimes get the vehicle up close to 55 when the transmission is failing. The transmission has a limp mode... basically second gear that it drops ...

...anything to do with it or duration of running time? What exactly do you mean by high speeds? 55-65mph or like 95 mph for prolonged periods? Do you notice your engine or transmission heating up at

...clog up, but they give signs as struggling to keep up at higher speeds. Has pressure, just no volume. The will go forever, say at 55 MPH, but try doing 60 MPH and the engine cuts out or stalls a

engine stalls13 times today. 35-55 mph no stress gas motor quits after 5 miles of driving and runs on electric until I can stop and restart the car. This happened 13 times this morning. car is at ford

...close, am idling at 35k RPM and hit 70k at 55 MPH There is an idle solenoid on the rear of the carb that you need to unplug,it was put there to keep the engine from stalling but you don't need