...remove the outer tie rod end from the inner tie rod, Remember count the turn very important to install it back. for you Toe Alignment. The inner tie rod end will you will need a tool call tie rod end ...
wire brush. If you got that far but can get the tie rod off the inner tie rod, loosen off the 7/8" jam nut, and use a pipe wrench to loosen off the tie rod, make sure you count the turns until removed
...inner and outter tie rod's. and a new idler arm. what can it be that need's to be done? with the front wheels of the ground remove the outer tie rods from the knuckles. Turn the knuckles by hand. Do ...
remove the inner bearing race from the hub. Remove the inner oil seal with the same tools used to remove the outer seal. To install: Place the inner race in the bearing. Support the knuckle and use an
inner CV boot on a '89 Chevy K2500 truck. How is the easiest way to accomplish this? You need to remove the shaft to do a good job (I don't recommend the split boots). Once the shaft is out, I usually
...Remove the halfshaft from the right side on automatic transaxle equipped vehicles and on all manual transaxles as follows: Insert a suitable prybar between the inner CV-joint and the transaxle. ...
...remove the inner shaft you may need a pry bar. No auto parts store or tool rental place I've ever talked to will rent you an impact wrench, so be ready to spring for between about $150 or so for a ...
2,484 questions posted
Usually answered in minutes!
907 Questions
707 Questions
348 Questions
103 Questions
32 Questions