2001 Jaguar S-Type "know calipers jeep" Questions

...know which one fits my car between Akebono caliper or ATE caliper 1999 Jeep Grand Cherokee v8, 4.7L VIN: 1j4g868nxxy510064 Many thanks, Allex Check this: ...

...the rotor from the Jeep. My car is jeep grand cherokee Limited from 1995 V8 and I need to change my enginer to another jeep grand cherokee limited V8 2002 I need to know if is possible or ...

know how to get the calipers of the front rotors I need to change my front end rotors and brake pads, but I can't seem to figure out how to get the calipers off. there should be two 13 mm bolts on the

...calipers.,bled the lines. car drove great fro 15 miles and then the right brake froze up again. was told by Jeep Dealer that it was the hydraulic repositioning valve.. does that soung right? It also ...

...calipers are wrong or on the wrong side and the bleeder is not atop caliper,also you bleed the rear also? these trucks and cars use left caliper and rt rear on one system of the master and rt front ...

...know.not being totally familiar with 2000 jeep but usually just remouve the caliper and maybe the caliper support held on by two bolts behind the rotor.some rotors are held on the hub with two small ...

...jeep grand cherokee lerado sounds like your alignment is off take it to a mechanic and have them test the alignment If you have changed the brakes recently, check your caliper bolts on the back side ...

caliper warping rotor. need to know which caliper to use to replace OEM part. good luck getting an oem go for a rebuilt or reman from Autozonr or Schucks. NEED TO KNOW WHICH ROTOR IS WARP.YOU CAN USE ...

jeep wrangler rubicon that is pulling to the left pretty hard when applying the brakes. I replaced the break pads and found that the right front caliper was stuck and the pads were completly worn off.

...know if that contributed to my problems. I've always used a hand 4-way type lug nut wrench. I recently read that they should only be tightened from 85-100 lbs/ft. I'm going to place the order for the ...