1998 Jaguar XK8 "close door window" Questions

...door. Reprogramming is also described in the owners manual. I don't know how mine became deprogrammed, should only happen if the battery is disconnected! bill man is right. with doors closed open ...

...door panels ,make sure the window plugs are even pluged up,, check the fuses,, but if i were you being such a new vehicle ,i would take it to the dealership,,warranty,,goodluck,,thanks You'll need to ...

...door close sensor. Windows were reprogrammed successfully after frost made them stick. This worked fine for a few days. Now driver's door will not admit its closed even though it is. Suggestions? ...

...close the door, I must roll down the window a fraction. \r\n I have tried the re-set option listed here - to no effect. This happened one day when I was getting out of the car - it just happened with ...

door but that did not close the rear windows nor did the switch to lower the top. I hear the motor run when pushing the convertible top switch but nothing happens. The prior day I smelled something in

...door window will not auto drop when i open the drivers door, but will operate normally by the window up and down switch? If the driver's side window is supposed to drop auto- matically,when you open ...

...close door press window switch down until window is all the way down hold your finger on the switch all the time and hold it there for 10-15 sec after the window is down then do the same but with the ...

...close position after door closes If you disconnect the battery you must reprogram both windows by holding the button down until you hear it chime takes about 5 or so seconds. Repeat for the other ...

window will not go back up after closeing doors,coyiues to go down each time you pull up on out side handle. To reset the windows you need to get in the car make sure both doors are completely shut. ...

...door closed. hold the down button you hear a clck a few seconds after it opens fully now hold the up/close button and again wait for the click. easiest is to hold the button pressed for 10 secs after ...