...door panel off (after removeing the inside handle), and use a philips head srewdriver to remove the old handle. watch how hey come off and interact with the metal bar / lathing assembly. if the door ...
...door and remove slowly incase there is any wiring or cables attached. (11) remove weather membrane carefully this has to be refitted if damaged you could end up with water leak into the car. (12) ...
...remove door latch Trying to remove door latch on 1995 thunderbird. Car has power locks. inside or outside latch? please rate Section 01-14A: Handles, Locks, Latches and Mechanisms 1995 Thunderbird, ...
...remove door panel: scews somewhere near arm rest pull possibly a couple along sides/bottom, factory clips can be popped by using thin,stiff flat tool (narrow putty knife),check release handle trim or ...
remove door panel pop electrical control up for the front and lift out then disconnect plugs. Use 7 MM socket to remove 2 screws under where handle is located. A Phillips screw driver removes the door
door or the retainer (marked by red arrow) would break off. When you get the 4 tabs to pop out, slide the entire plate holder up to remove from the retainer. You do not need to detach the lamp wiring.
...Remove the door panel. Remove the plastic cover from the door frame. Remove the power window switch from the door panel. Connect the power window switch to the door harness. Fully lower the glass. ...
...remove fuel filler hose(fuel filler door to tank-hose clamps) 5-place jack into position 6-remove straps/bolts securing fuel tank to underbody 7-lower down the tank slowly until you can access the ...
...door open and closed. Reprinted with permission. When the ohmmeter leads are connected to the sensor's input and output terminals, the ohmmeter reading should increase smoothly as the sensor vane is ...
1,443 questions posted
Usually answered in minutes!
1,131 Questions
1,082 Questions
517 Questions
500 Questions
255 Questions
