2001 Hyundai Accent "replace eraser stick" Questions

...9. Is PCSV working properly? YES ▶ Thoroughly check fuel vapor hoses and hose clamp and replace as necessary. Go to "Terminal and connection inspection" procedure. NO ▶ ...

SAME STORY--INTREPID IN LIMP MODE GATTING TROUBLE CODE 24-TPS SENSOR-BUT JUST REPLACED -I KNOW THE IAC IS STICKING ALSO-WOULD THIS PUT TRANNY IN LIMP MODE-THANKS Double check for clean/good ...

check engine light is on macanic said I need a new motor unit I have an 04. It was the pressure sensor in the fuel tank. Erased the codes, filled the tank...no problem in 8 months.(they stick from ...

...faulty. Most likely problem is TCC solenoid is faulty. Test solenoid out of vehicle if possible. Replace and

...need the black tube and the rubber piece that connects to it from the oil fill neck. it is an easy replacement also will need a o-ring for the black plastic piece that goes down to the bottom of the ...

when going around a corner car dies lost keys had lock smith rekey. when turning a corner car dies are tries to stall out? have you fuel pressure check for steady pressure normally 45 to 60 lbs and ...

2000 f-250 V10 computer sent code that oxygen sensor was bad so i replaced both of them still did not fix the prob but i erased the code and it has not come back it is kinda like a miss fire but there

3800 engine sputtering and cutting out up hills and at 50+ mph out of the blue my 1999 intrique started cutting out and hesitating at 50+ mph's, and a couple of days later started at 20+ mph's

...gear. Eventually the trans went while on the highway. Vehicle trans shifted all over the place. I replaced my trans (keeping the old wiring) and found that it would not shift out of 1st gear. The ...

...Replace cap with about 3 clicks this is enough. If your check engine light is on the cars computer wil erase after a few miles. GOOD LUCK FRIEND. Yes, the Check Engine Light (CEL) triggers when ...