how to time a 2000 hyundai accent 1.5 sohc motor? how to align the cam and crank marks before installing the timing belt? Make sure those 2 marks are alligned durring reinstal
...2 got a little over 100psi #3 got approx. 118 psi and #4 got 121psi i know that #1 probally has a bbad valve but i dont know what is a good # to say if the rest are good or do i need to replace any ...
...2) Remove the water pump pulley, using a socket. Remove the crankshaft pulley bolt, using a ½-inch drive socket followed by the pulley. Remove the upper and lower timing belt covers, using a ...
...cam sensor Three times,ecm once, absolutely baffled; note one other test i didnt mention ,we pulled fuses w koeo while monitering the volts fromcam snsr posit#2 connector, and found that the volts ...
...2 sensors on your car and the TOP sensor is prbobobly not the problem, most people get the cam sensor and put it on the top of the motor, Wrong! its shorter because it goes on the bottom side of the ...
...cam position sensor would be located on top of the cylinder head, not in the engine block. It's located between the valve cover (the very top of the engine, the oil cap is on it) and the coil pack ...
...timing belt breaking. Had head professionally rebuilt. cylinders 1, 2 & 3 have 120# compression. checked compression prior to putting in cams (all valves closed) compression came in at about 45# ...
...2 components that I would suspect would be the Coil pack and the Cam sensor. I had a similar issue on a Sorento. Intermittent miss on one of the cylinders. The Coil pack was bad. When I replaced it, ...
...cam shaft rotation. This is what is referred to as stting the timing in the engine, and the timing of the distributor. Since your belt is broken the engine has lost track of its timing, so you might ...
1,521 questions posted
Usually answered in minutes!
1,131 Questions
1,047 Questions
517 Questions
500 Questions
255 Questions